Description
The JK 200A PB2A16S20P BMS offers advanced protection for LiFePO4 batteries, managing up to 16 cells (16S) and providing a continuous discharge current of 200A. Equipped with active balancing functions and protection against overload, overcharge, overdischarge and short circuit, this BMS optimizes the performance of your battery.
Main features:
- Rated current: 200A
- Support for up to 16S (16 LiFePO4 cells)
- RS485 and CAN communication for easy integration with other systems
- Active balancing between cells for extended battery life
- Multiple protections: against overload, overcharge, overdischarge and short circuit
- Remote monitoring and control via communication interface
Wiring diagram
The protection board has strict requirements on the power supply order. Connect in order from low to high potential: B-, P-, B+, P+. After powering on, press the button to activate. Connect all wires before connecting the load or charger. To disconnect, first remove the load and charger. Then, disconnect the cell sampling connectors in order from high to low potential, and finally remove B+, P+, B-, and P-.
size
DIP Switch settings for battery address
When multiple battery packs are connected in parallel, the address of each pack must be set differently via a DIP switch for correct operation. The DIP switch address table is shown below.
| AddressPosition | ||||
| 1234 | ||||
| 0OFFOFFOFFOFF | ||||
| 1ONOFFOFFOFF | ||||
| 2OFFONOFFOFF | ||||
| 3ONONOFFOFF | ||||
| 4OFFOFFONOFF | ||||
| 5ONOFFONOFF | ||||
| 6O | FFONONOFF||||
| 7ONONONOFF | ||||
| 8OFFOFFOFFON | ||||
| 9ONOFFOFFON | ||||
| 10OFFONOFFON | ||||
| 11ONONOFFON | ||||
| 12OFFOFFONON | ||||
| 13ONOFFONON | ||||
| 14OFFONONON | ||||
| 15ONONON | ON | |||
Reviews
There are no reviews yet